Filters
Close

Waste Pipe & Fittings

Display per page

MFP Waste 45 Degree Bend Grey

WPB41GRange
Waste bends are used to create tight, neat 45 degree bends in a waste pipe system
£1.75 excl vat

MFP 32mm 90 Degree Waste Knuckle Bend Grey

WPB33G
Knuckle bends are used to create tight, neat 90 degree bends in a waste pipe system. They have a tighter radius than the standard swept bends.
£1.69 excl vat

MFP Waste 45 Degree Bend Grey

WPB31GRange
Waste bends are used to create tight, neat 45 degree bends in a waste pipe system
£1.69 excl vat

MFP Waste Saddle Clip Grey

WC3GRange
This Waste Saddle Clip is used to fix a waste pipe back to a wall.
£0.77 excl vat

MFP Waste Coupler Grey

WPC3GRange
Couplers are used to connect two cut lengths of pipe.
£1.69 excl vat

MFP Waste Pipe 3m Grey

WPP33GRange
Waste pipes are used to convey waste water, often referred to as foul drainage, to the above or below ground drainage system.
£4.56 excl vat

MFP 40mm-32mm Waste Reducer Grey

WPR43G
This waste reducer is used when a 32mm waste pipe is connected into a 40mm pipe, usually with the 32mm pipe dropping into the 40mm pipe below it running towards the soil pipe.
£1.69 excl vat

MFP Waste Tee Branch Grey

WPT31GRange
Waste tees are used in two different ways. Their main use is to connect a section of waste pipe into an existing pipe run. The tee is swept to ensure that the new section flows into the main run in the correct direction of flow. In most kitchen and bathroom applications the branch section drops into a main pipe run that is situated below it. The second use for a tee is to create a 90 degree bend with access for cleaning. This is achieved by using an access plug in the part of the swept tee that is at the opposite end to the direction of flow.
£1.69 excl vat